HAND & POWER TOOL BEST PRACTICES HAND & POWER TOOL BEST PRACTICES Company Harlan McPhee North McPhee South Powerhawke Ravex Richards Company Using the Form Job Name * Job Name and/or Number Date * Additional Comments Foreman Name * Attended By (Required) HAND & POWER TOOL BEST PRACTICES Listed below are some of the best practices we need to observe to make sure we safely complete our work. *Know the tool you are using, its application, limitations and potential hazards. Never use a tool you were not trained to use. Don’t be shy about asking for help. *Select the proper tool for the job. Screwdrivers are NOT pry bars. Use a proper wire stripping tool instead of a razor knife. *Don't tackle a big job with an undersized tool - make-shift tools can cause injuries. *Use GFCI for all tools unless they are double insulated. A double insulated tool usually has a plastic or non-conductive outside housing and 'double insulated' embossed into the case or stamped on the manufacturer's label. *If the tool is equipped with a three-prong plug, it should be plugged into a three-hole receptacle or extension cord. Never break off the ground prong; it's there for your protection. *Always remove adjusting keys and wrenches before turning on the tool. Only make adjustments or blade changes when the tool is unplugged, or the battery is removed. *Keep your work area free of clutter and debris. These can become tripping hazards. Proper housekeeping is critical to a safe jobsite. *Tool guards are designed to make tools safer. Never remove or wedge a guard out of the way. If the drill comes equipped with a side handle, make sure it is installed and used. Today’s power tools can generate a lot of torque, which can cause injuries if the drill bit binds. *Construction sites change constantly. Always be aware of your surroundings and alert to potential hazards in your work area. Use the 20/20/20 rule. *Avoid accidental start-up of power tools. Make sure the switch is OFF before plugging in the cord or when the power has been interrupted. *Make sure saw blades, drill bits, router cutters, etc., are sharp, clean and regularly maintained. If the tool is not in use, remove the blade or store the tool in the manufacturer’s case. *Use only recommended accessories and follow the manufacturer's instructions for operation. This includes the use to two hands for operations, when called for in the operators manual. *Do not force the tool. Each tool can do a better job at its designed speed. Do not over-reach. Keep proper footing and balance at all times. *Dress properly. Avoid loose clothing, gloves and jewelry that could catch in moving parts. *Secure your work. Use clamps or a vise to hold your work whenever practical. *Never use a tool with a frayed or damaged cord. If the outer jacket is compromised, do not just put a couple wraps of electrical tape. Bring it to the attention of your supervisor, so that he can get it properly repaired or replaced. *Do not attempt any field repairs. Return broken tools to the shop for proper repair. *After use, return the tool to its original carrying case and store in a dry, secure location. Does anyone have any other Best Practices they would like to share? Any Lessons Learned from past tool incidents? FOLLOW THESE GUIDELINES AND YOU WILL FIND THAT TOOLS PERFORM BETTER, OPERATE MORE SAFELY, AND LAST LONGER. Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Picture Upload Drop a file here or click to upload Choose File Maximum upload size: 52.43MB reCAPTCHA Submit Δ
