Arm Protection Arm Protection Company Harlan McPhee North McPhee South Powerhawke Ravex Richards Company Using the Form Job Name * Job Name and/or Number Date * Additional Comments Arm Protection We have done a very good job lately focusing on protecting our hands. As a result of this we have seen a significant reduction in hand lacerations. What we may not pay as much attention to is protecting our arms. Below are a few injuries and information to help mitigate this hazard in the future. As an electrical contractor we have seen many arm injuries from metal studs. These usually manifest themselves in one of two ways: 1) The employee comes in contact with the stud by brushing up against it (trying to work between the studs, coming down off a ladder and rubbing against the edge, etc.) It may not seem like the edge is very sharp, but contact with the stud along the edge will likely end up in a laceration. 2) Manually pulling wire in and the string breaks, the string comes untied from the wire or the hand slips and a forceful contact is made with the edge of the stud causing an injury. We have seen arm lacerations from this on electrical panels as well. While it is not practical to attempt to make all the stud edges safe (other than your immediate work area or putting the drywall up), while working in a panel, it could be practical. We have also seen arm lacerations from drop ceiling frames and handling of light fixtures themselves. Everyone should be aware of the hazards associated with their work and wear arm protection where it is appropriate. This is best identified in the daily tailboard talk or pre-job brief. Failure to wear the appropriate PPE can result in lacerations, and other serious incidents. • Prior to performing work, always review the work area for both visible hazards and hazards that may become present during the course of work. • During work, each employee must be aware of all hazards and take into consideration steps to reduce the hazards. If the hazards cannot be removed or isolated, appropriate PPE and body positioning needs to be evaluated and implemented. • Use of Kevlar sleeves should be considered when performing work around potential laceration hazards. Thumb holes help hold the protective sleeves in place and prevent “roll-up” when performing work. • Always try to utilize a tool instead of placing body parts in hazardous areas. Foreman Name * Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Toolbox Talk Attendee Attended By (Required) Picture Upload Drop a file here or click to upload Choose File Maximum upload size: 52.43MB reCAPTCHA If you are human, leave this field blank. Submit Δ
